This is a P8X32A/Propeller, P2X8C4M64P/Propeller 2 driver object for Microchip MCP9808 Temperature sensors
IMPORTANT: This software is meant to be used with the spin-standard-library (P8X32A) or p2-spin-standard-library (P2X8C4M64P). Please install the applicable library first before attempting to use this code, otherwise you will be missing several files required to build the project.
- I2C connection at up to 400kHz
- Read temperature in hundredths of a degree
- Set temperature scale to Celsius or Fahrenheit
- Power sensor on/off
- Interrupts: set low, high, critical thresholds, enable low, high, critical, or only critical interrupts, set interrupts active low or active high, set comparator or interrupt output mode
- Supports alternate slave addresses
P1/SPIN1:
- spin-standard-library
- 1 extra core/cog for the PASM I2C engine (none if bytecode-based engine is used)
- sensor.temp_rh.common.spinh (source: spin-standard-library)
P2/SPIN2:
- p2-spin-standard-library
- sensor.temp_rh.common.spin2h (source: p2-spin-standard-library)
| Processor | Language | Compiler | Backend | Status |
|---|---|---|---|---|
| P1 | SPIN1 | FlexSpin (5.9.21-beta) | Bytecode | OK |
| P1 | SPIN1 | FlexSpin (5.9.21-beta) | Native code | OK |
| P1 | SPIN1 | OpenSpin (1.00.81) | Bytecode | Untested (deprecated) |
| P2 | SPIN2 | FlexSpin (5.9.21-beta) | NuCode | FTBFS |
| P2 | SPIN2 | FlexSpin (5.9.21-beta) | Native code | OK |
| P1 | SPIN1 | Brad's Spin Tool (any) | Bytecode | Unsupported |
| P1, P2 | SPIN1, 2 | Propeller Tool (any) | Bytecode | Unsupported |
| P1, P2 | SPIN1, 2 | PNut (any) | Bytecode | Unsupported |
- TBD