-
|
Hello your latest firmware 2.1.x with new input shaping work with my "genius pro" with auto bed leveling? Thanks |
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 1 reply
-
|
Hello @gabfus , glad that it is working for your genius pro, not sure if it is 100% compatible...as it is prepared for artillery genius (not pro). Best regards. |
Beta Was this translation helpful? Give feedback.
-
|
Hi @gabfus , just created a Genius PRO version of the firmware, so I recommend you to try it. Best regards. |
Beta Was this translation helpful? Give feedback.
Hello @gabfus ,
glad that it is working for your genius pro, not sure if it is 100% compatible...as it is prepared for artillery genius (not pro).
Auto bed levelling has not been configured in this software as it was not planned for the BL touch version.
As far as I know it depends on several factors(material, calibration, in summary how fine tuned is your printer).
In the other hand I´m not an expert on speed printing, but I recommend you to test it on your own increasing progressively the speed.
Best regards.